Request a call-back

Sparking Outlet or Switch in Wichita, KS?

A tiny, single spark when a plug makes contact can be normal. Repeated sparks, a flash when you use a switch, crackling, or a hot or marked plate is a reason to stop using that device and have it inspected.

Request a call-back

This is a free referral service that connects people in Wichita with independent local licensed electricians. We are not an electrical contractor and we do not do the work ourselves.

Free referral service. We connect you with an independent local electrician and do not do the work ourselves. Calls may be recorded.

What to do right now

  1. Stop using the outlet or switch. Unplug the cord only if it is safe and nothing is smoking.
  2. If there is smoke or fire, leave and call 911.
  3. Switch off the breaker for that circuit if you can identify it.
  4. Do not tape over a damaged plug or keep using a scorched device.
  5. Request a call-back and say whether the sparking is at an outlet, a switch or a fixture.

When this is an emergency

Smoke, fire, a downed line, or danger to life? Leave the area and call 911. For a downed power line, also call the electric utility. Do not wait on a referral call-back.

After the circuit is off

Once the device is out of service and the breaker is off, you can usually request a same-day call-back rather than standing by for a fire crew, unless there is still smoke, heat or a smell that is getting worse. Do not turn the breaker back on to 'test it again' while you wait.

In Wichita

Older neighborhoods such as College Hill, Riverside, Delano and Linwood often have mid-century panels, original receptacles and fewer circuits than modern loads use.

Related services

Related problems

In the Wichita area

We also refer people in these communities:

See the full service area.

See all common electrical problems in Wichita or the emergency electrician cost guide.

Common questions

Is a spark always dangerous?

A small, single spark when plugging in a cord can be normal. Repeated sparking, crackling, heat or discoloration is not. When in doubt, take the device out of service.

Can I just replace the outlet?

Replacing the device may be all that is needed, or there may be a loose connection, damaged cable or an overloaded circuit behind it. An electrician can inspect the box, not only swap the device. In many places that work also has to be done to code.

The switch pops when I turn on the lights. What is that?

A failing switch, a failing fixture, or a problem in the box can all cause a pop or a flash. Switch that circuit off and request a call-back.

Request a call-back

This is a free referral service that connects people in Wichita with independent local licensed electricians. We are not an electrical contractor and we do not do the work ourselves.